Krypton P H.T.W. Controller is a modern regulator for fine coal and hopper boilers with a H.T.W. pump. Different types of housings in which the controller is available allow its mounting on the boiler or a tank with fuel, on the wall in the boiler room, under the boiler construction, in the control cabinet, on a bus. Krypton P microprocessor controller is designed to control the blower, a circulating pump and the H.T.W. pump in the C.H. systems. It has an output for connecting a remote control.
- a flexible adjustment of the blower speed
- controlling a C.H. circulating pump
- H.T.W. pump control
- using a remote control (PILOT) or a room thermostat
- an anti-freeze system below 5°C
- an anti-stop system to prevent the stopping of pumps
- the ability to set the minimum and maximum blower speed (operation with different types of blowers)
- gradual switching the blower from minimum to maximum speed
- fuel shortage check
- easy to read LED display
- easy to use menu
- available in various types of housings
* The regulator is also available in the enhanced version (for high power boilers, supporting two blowers)
The 1T housing enables a quick installation of sensors and additional devices, such as a remote control PILOT.
In addition, there is the possibility of installing the regulator in this housing on the bus in the control cabinet. Specially designed stands of a housing allow the fixing of neodymium magnets in them which when installed on the boiler prevents the controller from moving.
Krypton P controller in a 1S housing - Version for the installation on the boiler or next to the boiler on the wall, a panel at an angle, cables extending from the rear of the controller housing. Support for two blowers in the enhanced version
Krypton P controller in the 1T plastic housing - A version for installing on the boiler or next to the boiler on the wall, the panel at an angle, the cables extending from the back of the controller housing, housing made of plastic, wires terminated with network sockets. Sensors disassembled with couplings
Krypton P controller in a 2S housing - The 2S housing allows the assembly of some of the wiring under the insulation of the boiler. Inside there is an operating module mounted on the bus, which greatly simplifies installation and removal of the module
Krypton P controller in the 3S housing - The 3S housing, a version for mounting on the boiler or a tank with fuel; the holes in the bottom of the controller allow placing some of the wiring under the insulation of the boiler
Krypton P controller in a full 1S housing - The full 1S housing allows full assembly of some of the wiring under the insulation of the boiler, the panel is mounted in the front wall of the boiler
module + panel - working module and a panel, separately (without the metal casing). Special operator's panel with locks enables it to be mounted on the facade of the boiler. Moduł wykonawczy posiada specjalne zatrzaski za pomocą których mocuje się go na szynie DIN 35mm – The working module has special locks with which it is mounted on 35mm DIN bus
Krypton PS H.T.W. in a drawer housing. The 2S drawer housing makes it possible to install the entire controller under the insulation of the boiler. On the back of the housing there are sockets for connecting devices such as a blower and a pump. Clamp sockets allow for a quick installation of additional sensors without the use of tools. The operator's panel is installed in the front wall of the boiler insulation.
Regulator operating system
Układ z pompą CO, CWU i ręcznym zaworem mieszającym