Controller TITANIC 3

DESCRIPTION

Titanic is a controller designed to control the operation of a central heating boiler with a screw feeder or piston feeder (with a feeder position sensor). This regulator has the option of weather control. After connecting an additional external temperature sensor, the controller calculates the boiler setting according to the heating curve set by the user. In addition, the Titanic controller supports remote control - PILOT or a room thermostat, to increase the comfort of using the controller, it is possible to stabilize the temperature in the room by using these additional devices.

Language versions

              
 

           

SPECIAL FEATURES

FUNCTIONS

- smooth blower speed control
- control of the piston / auger feeder switched in options
- control of the CH circulation pump
- control of the pump loading the DHW tank
- PILOT or room thermostat operation
- possibility of weather-based control of the boiler temperature*
- weekly control of the central heating and hot water circuits
- SUMMER operation modes (operation of the DHW loading pump only), DHW PRIORITY (additional heating of the DHW tank first), NO DHW (DHW pump operation off)
- anti-freeze system below 5 °C
- anti-stop function to prevent pump stagnation
- screw feeder jam monitoring
- clear LCD display
- easy to use menu

*the weather sensor must be purchased separately

VERSIONS

1S - Version for installation on the boiler or next to the boiler on the wall, the panel at an angle, cables from the back of the controller housing

1SK - Version for installation on the boiler or next to the boiler on the wall, the panel at an angle, cables from the back of the controller housing

1S pełna - version for installation behind the boiler, panel for installation in the front wall of the boiler insulation. Openings in the bottom of the casing allow sensors, panel tape and some cabling to pass through the boiler insulation

0S - Version for installation on high boilers, where the use of 1S housing could cause problems with the operation of the keys

2S - version for mounting on the boiler, the holes in the bottom part of the controller allow for some wiring to pass under the boiler insulation

3S - version for installation on a boiler or a tank with fuel, openings in the bottom part of the regulator allow for carrying out some cabling under the boiler insulation

1R - version for installation on a boiler or a fuel tank, cable outlet at the rear of the controller. The logotype on the right side may be replaced with the logo of the heating device manufacturer.

Module + panel - version for mounting on a rail, e.g. in a control cabinet, panel for mounting in the front wall of boiler insulation

1T - Version for installation on the boiler or next to the boiler on the wall, panel at an angle, wires on the back of the controller housing, plastic housing, wires on connectors

SW1 - version for servicing large boilers, installation on the boiler body, servicing of 3-phase devices.

SW2 - The controller in this housing can operate a 550W blower. Installation on the boiler housing. 

Reinforced versions

- reinforced version: 550W blower 250W feeder 250W pump available in 1S, 1S full, 0S housings (here no photo, only information that there are two reinforced versions)

- reinforced version: blower, feeder for contactor: a contactor coil can be connected to the feeder output, a reinforced blower 550W pump 250W, available in 1S, 1S full, 0S enclosures

REGULATOR WORKING SYSTEM

System with a CH pump and a DHW pump